7.4.  Invert

Revision History
Revision $Revision: 1912 $ 2006-08-15 scb

The Invert command inverts the selection in the current image. That means that all of the image contents which were previously outside of the selection are now inside it, and vice versa. If there was no selection before, the command selects the entire image.

[Warning] Warning

Do not confuse this command with the Invert layer command.

7.4.1.  Activating the Command

  • You can access this command from the image menubar through SelectInvert. In addition, you can use the Selection Editor to access it.

  • You can also use the keyboard shortcut Ctrl-I.