| 3.2. Propriétés | ||
|---|---|---|
|
3. The Quick Mask |  |
| 3.2. Propriétés | ||
|---|---|---|
|
|
3. The Quick Mask | |
There are two Quick Mask properties you can change by right-clicking on the Quick Mask button.
Normally the Quick Mask shows unselected areas « fogged over » and selected areas « in clear », but you can reverse this by choosing « Mask Selected Areas » instead of the default « Mask Unselected Areas ».
Use « Configure Color and Opacity… » to open a dialog that allows you to set these to values other than the defaults, which are red at 50% opacity.
