### 5.5. Measure

The Measure Tool is used to gain knowledge about pixel distances in your working image. By clicking and dragging the mouse button, you can determine the angle and number of pixels between the point of click and where the mouse pointer is located. The information is displayed on the status bar or can also be displayed in the Info Window.

A common use case for Measure is to calculate the angle of rotation when horizon is uneven on a photo. To rotate in order to straighten the horizon, click the Straighten button after measuring the angle.

This button can be used in straightening horizontal or vertical lines up: the starting point comes with a small bar that shows the direction.

When you pass the mouse pointer over the end point it turns to a move pointer. Then if you click you can resume the measure.

Information is displayed in the status bar, at the bottom of the Image window:

• Distance between the original point and the mouse pointer, in pixels.

• Angle, in every quadrant, from 0° to 90°.

• Pointer coordinates relative to the original point.

#### 5.5.2. Aktivera verktyget

There are different possibilities to activate the tool:

• From the main menu: ToolsMeasure.

• By clicking the tool icon in the Toolbox.

#### 5.5.3. Tangentmodifierare (standardvärden)

Skift

While holding down the Shift key, click and drag from an existing endpoint to create a second measurement line from this endpoint. The angle between the two lines will be displayed. Any endpoint can be moved by clicking and dragging. So, you can measure any angle on the image:

Ctrl

Holding down the Ctrl key puts the tool into constrained straight line mode. The orientation of the line is constrained to the nearest multiple of 15 degrees.

Ctrl key pressed and click on an end point creates a horizontal guide. The mouse pointer goes with the icon.

In Horizontal or Vertical Orientation modes, Ctrl also toggles between Horizontal and Vertical.

Alt

Alt key and click on an end point creates a vertical guide.

Ctrl+Alt

This key combination and click on a measure line allows to move the measure.

Ctrl+Alt key combination and click on an end point creates a vertical and a horizontal guides.

#### 5.5.4. Alternativ

Orientation (Ctrl)

In the Auto mode (default), will snap to the smallest angle between the measure line and the vertical or horizontal direction. Horizontal and Vertical allow to override this behavior by specifying explicitly what it should be.

Use Info Window

This option will display an Info Window dialog that details the measure tool results. The results are more complete than on the status bar.

Straighten

Transform, Interpolation, and Clipping are treated in Avsnitt 4.1.1, ”Verktygsalternativ”. Here is an example for straightening a path:

Ursprunglig bild

Draw path

Make path visible

Draw measure line on the segment you want to straighten

Straighten

: click on this button to perform straightening.

#### 5.5.5. Measuring surfaces

You can't measure surfaces directly, but you can use the Histogram that gives you the number of pixels in a selection.