| 5.4. Dot for Dot | ||
|---|---|---|
|
5. The „View“ Menu |  |
| 5.4. Dot for Dot | ||
|---|---|---|
|
|
5. The „View“ Menu | |
The command enables and disables „Dot for Dot“ mode. If it is enabled (checked) and the zoom factor is 100%, every pixel in the image is displayed as one pixel on the screen. If it is disabled, the image is displayed at its „real“ size, the size it will have when it is printed.
The example below will illustrate this. Imagine the following image properties:
Image size: 100×100 pixels
Image resolution: 300 ppi (pixels per inch)
Image displayed with Zoom=100%, „Dot for Dot“ enabled:
100×100 pixels
Image displayed with Zoom=100%, „Dot for Dot“ disabled:
100 pixels ÷ 300 ppi = 1/3 inch ≅ 0.85 cm
For Dot for Dot mode to work properly, the resolution of the image must be the same as the screen resolution in the Preferences menu.
Enabling this mode is recommended if you are working on icons and web graphics. If you are working on images intended to be printed, you should disable Dot-for-Dot mode.
